24 × 24 ft area: the short answer
Covered 3 inches deep with crushed stone, a 24 × 24 ft area needs about 7.20 tons of gravel — about 5.33 cubic yards (144 cubic feet).
Area size
Gravel for a 24 × 24 ft area
A 24 × 24 ft area covered 3 inches deep with crushed stone needs about 7.20 tons of gravel — that's 5.33 cubic yards, or 144 cubic feet. Change the depth and stone type below.
Gravel needed
—Enter area and depth to estimate gravel.
| Base quantity | — |
|---|---|
| Order weight | — |
| Order volume | — |
| Base volume | — |
| Allowance | — |
| Estimated cost | — |
Shopping list
Run the calculator to prepare a list.
Estimate only.
Gravel is sold by the (short) ton or cubic yard. Weights use approximate densities that vary
with stone size, moisture, and compaction — order about 5–10% extra for spreading and
settling, and confirm tonnage with your supplier.
Adjust for your job
Lighter stone like pea gravel weighs a little less per yard; a driveway base goes deeper than a path. Change depth and stone type in the calculator, and order 5–10% extra for spreading.
Approximate crushed-stone density at 3″; 1 ton = 2,000 lb. Estimates only.
What a 24 × 24 ft area is usually used for
A 24 × 24 ft area is a large pad: room for two cars, a wide driveway section, a boat or equipment area, or a big patio. At this scale, the surface layer alone is a meaningful delivery, and the base layer, drainage, and edge plan typically determine whether the finished surface stays level.
How to decide
Large pads need the base and surface planned as separate lifts. A common driveway approach is a compacted base of larger crushed stone with a finer surface layer on top; depth on each layer depends on soil and traffic. Use the calculator for each lift separately rather than entering one combined depth.
Checks before you order
- Plan the base and surface as separate quantities and check both against supplier units.
- Verify access for delivery; a full truck or dump trailer needs a route that can handle it.
- Confirm drainage so the pad does not pond water or wash stone into the lawn.
FAQ
How much gravel for a 24 × 24 ft area?
At 3 inches of crushed stone, a 24 × 24 ft area needs about 7.20 tons (5.33 cubic yards, 144 cubic feet). A 4-inch driveway base needs about a third more — set your depth in the calculator.
How many cubic yards of gravel for a 24 × 24 ft area?
About 5.33 cubic yards at 3 inches deep. Suppliers sell by the ton or the cubic yard, so the calculator shows both — order about 5–10% extra for spreading and settling.
Sources & verification
Source links and page assumptions reviewed .
- QUIKRETE: All-Purpose Gravel product data — Manufacturer product data for washed, graded gravel used in landscaping and drainage.
Estimate only, based on approximate crushed-stone density at 3″ depth. Weights vary with stone size, moisture, and compaction. Confirm tonnage with your supplier before delivery.