12 × 24 ft area: the short answer
Covered 3 inches deep with crushed stone, a 12 × 24 ft area needs about 3.60 tons of gravel — about 2.67 cubic yards (72 cubic feet).
Area size
Gravel for a 12 × 24 ft area
A 12 × 24 ft area covered 3 inches deep with crushed stone needs about 3.60 tons of gravel — that's 2.67 cubic yards, or 72 cubic feet. Change the depth and stone type below.
Gravel needed
—Enter area and depth to estimate gravel.
| Base quantity | — |
|---|---|
| Order weight | — |
| Order volume | — |
| Base volume | — |
| Allowance | — |
| Estimated cost | — |
Shopping list
Run the calculator to prepare a list.
Estimate only.
Gravel is sold by the (short) ton or cubic yard. Weights use approximate densities that vary
with stone size, moisture, and compaction — order about 5–10% extra for spreading and
settling, and confirm tonnage with your supplier.
Adjust for your job
Lighter stone like pea gravel weighs a little less per yard; a driveway base goes deeper than a path. Change depth and stone type in the calculator, and order 5–10% extra for spreading.
Approximate crushed-stone density at 3″; 1 ton = 2,000 lb. Estimates only.
What a 12 × 24 ft area is usually used for
A 12 × 24 ft area is a practical planning size for a wider path, a parking pad for one car, a patio base, or a garden work area. The wider footprint means the stone has to distribute weight as well as look even, so base preparation matters more than it does on a narrow walkway.
How to decide
At this footprint, ask whether the surface will carry vehicle or foot traffic. A parking pad usually needs a compacted sub-base with angular crushed stone that locks together, while a path or decorative bed can use a thinner single layer. Run the calculator at your actual depth and add the base layer as a separate quantity.
Checks before you order
- Identify the heaviest use (feet, bicycles, or a vehicle) before choosing depth and stone.
- Check whether the site slopes or collects water, which can shift stone without edge restraint.
- Get a supplier quote in the unit they sell by and compare it with the calculator totals.
FAQ
How much gravel for a 12 × 24 ft area?
At 3 inches of crushed stone, a 12 × 24 ft area needs about 3.60 tons (2.67 cubic yards, 72 cubic feet). A 4-inch driveway base needs about a third more — set your depth in the calculator.
How many cubic yards of gravel for a 12 × 24 ft area?
About 2.67 cubic yards at 3 inches deep. Suppliers sell by the ton or the cubic yard, so the calculator shows both — order about 5–10% extra for spreading and settling.
Sources & verification
Source links and page assumptions reviewed .
- QUIKRETE: All-Purpose Gravel product data — Manufacturer product data for washed, graded gravel used in landscaping and drainage.
Estimate only, based on approximate crushed-stone density at 3″ depth. Weights vary with stone size, moisture, and compaction. Confirm tonnage with your supplier before delivery.